Measurement Guide

JACKET MEASUREMENT GUIDE

Measurements A, B, C, D and F are round measurements
Measurements E, G, H and I are length measurements.

Grab a jacket you already own (one that best fits you) and compare your measurements with the sketch above. Make sure to keep the tape straight when measuring; avoid bending or folding.

A. FULL CHEST CIRCUMFERENCE [Measure from the bottom of one armhole, across the chest and round your back to the initial armhole starting point]

B. FULL WAIST CIRCUMFERENCE [Measure around your natural waistline, which is the narrowest part of your waist]

C. FULL BICEP CIRCUMFERENCE [Place the measuring tape in the middle of the upper arm and measure round your bicep]

D. FULL CUFF CIRCUMFERENCE [Measure the width of your cuff by placing the measuring tape at one corner of the cuff going round the sleeve and back to the initial starting point]

E. FRONT LENGTH [Lift up collar and measure from the highest point of the shoulder seem drop-down to the bottom of the jacket in a straight line]

F. SEAT CIRCUMFERENCE (BOTTOM HEM) [Measure around the bottom of the jacket without creasing or folding]

G. SHOULDER WIDTH (POINT-TO-POINT) [Measure straight across back from high point of one armhole seam to the other armhole seam. Ensure the upper edge of the measuring tape meets the shoulder seem for both armholes at the top]

H. BACK LENGTH [Measure straight down from center back neck seam to bottom of jacket]

I. SLEEVE LENGTH [Measure from the tip of the shoulder seam down along outer edge to the bottom of the sleeve opening]

Trouser Measurement Guide

Measurements A, B, G, H, I and J are round measurements
Measurements C, D, E and F are length measurements

Compare your regular trouser measurements (Not High-Waist) with the sketch above. Make sure to keep the tape straight when measuring; avoid bending or folding.

A. WAIST CIRCUMFERENCE [Measure around where you normally wear your waistband/belt]

B. SEAT/ HIP CIRCUMFERENCE [Measure around the widest part of your seat/hips]

C. FLAP [Measure straight downwards from the top of your waistband to the bottom of your zipper. The measuring tape should be along your fly]

D. EXTENDED FLAP [Measure straight downwards from the top of your waistband to just below your groin. The measuring tape should be along your fly and end where your trouser groin-seams meet]

E. TROUSER LENGTH [Measure from the top of your waistband, along the side of your leg to your ankle (or your desired length)]

F. SHORTS LENGTH [Measure from the top of your waistband, along the side of your leg. The measuring tape should end 3(three) inches above the middle of your knee cap ( or your desired length)

G. STOMACH CIRCUMFERENCE [Measure around the largest part of your stomach]

H. THIGH CIRCUMFERENCE [Measure around the largest part of your thigh. This is usually where the inner thigh begins]

I. KNEE CIRCUMFERENCE [Measure around the widest part of your knee]

J. CUFF CIRCUMFERENCE [Measure around your cuff. Provide the exact cuff size that you would like]

See size chart below for sizing preferences